SerVision CVG-M Informações Técnicas descarregar pdf (Página 192)

SerVision Embedded Video Gateway System Guide

Appendix A: Viewing Video on a CCTV Monitor (TV-Out) 191

Figure 217: Picture Params screen

2. Under Camera, select the number of the camera whose settings you want to modify. Video from this camera

is displayed in the upper-right corner of the screen.

3. Under Brightness, select the arrows to the right or left of the slider bar to adjust the brightness, as follows:



Single arrows – and : Adjust the brightness in small increments.



Double arrows – and : Adjust the brightness in large increments.

The camera settings are changed, and the video displayed in the camera pane in the upper left of the screen

changes accordingly.

4. Under Contrast, select the arrows to the right or left of the slider to adjust the contrast, as described in step 3

above.

The camera settings are changed, and the video displayed in the camera pane in the upper left of the screen

changes accordingly.

5. When the brightness and contrast are set as you want them to be, exit the menu by selecting one of the

following buttons:



Done: Return to live video display. The settings remain in effect until they are manually changed again or

until the Video Gateway restarts. When the unit restarts, the previous settings are implemented again.



Save: Save the settings on the Video Gateway. The next time the unit restarts, the unit’s configuration is

updated with the new settings. The settings remain in effect until they are manually changed again, either

on the monitor or in the configuration utility.



Back: Return to the Config menu. The settings remain in effect until they are manually changed again or

until the Video Gateway restarts. When the unit restarts, the previous settings are implemented again.

Adjusting Loop Interval and Screen Saver Settings

Initial loop-interval and screen-saver settings are set in the configuration utility (see Configuring a CCTV Monitor

(TV-Out), page 28). You can modify these settings on the monitor, and, if you wish, save the new settings to the

unit’s configuration.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 202 203

Sem comentários

SerVision CVG-M Informações Técnicas Página 192