SerVision CVG-M Informações Técnicas descarregar pdf (Página 37)

SerVision Embedded Video Gateway System Guide

Configuring System Settings 36

Figure 35: System Restart Page after manual time updating

In two cases, the screen that is displayed may differ from the one in figure 35: if there were unsaved updates

when the time was synchronized, and if the clock was set ahead more than about 15 minutes. For information

about handling these cases, see page 36.

3. Click Restart System. The unit restarts, and the time on the unit is fully updated. You are automatically

logged out of the configuration utility, and a confirmation message appears:

Figure 36: Restart confirmation message

Note: To continue configuring the unit, click the link in the message and log into the configuration utility

again.

Note: If you do not reset the unit at this time, the time setting is partially implemented. The next time the unit

is reset, the time change is fully implemented.

Under normal circumstances, after you click the Sync time with PC button, the System Restart Page appears as

in figure 35. However, if you made changes to other configuration settings before you updated the time, and did not

yet save them on the unit (i.e., you clicked Update in one or more of the screens, but did not yet save the changes in

Sync Time confirmation message

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 202 203

Sem comentários

SerVision CVG-M Informações Técnicas Página 37